3868 Goni Rd, Carson City, Nevada 89706Fax: (775) 882-2693Nevada Contractors License 46276Phone: (775) 882-3319
Industrial Logistics Services badgeIndustrial LogisticsServices, Inc.Machinery moving & installation(775) 882-3319

Grouting

Grouting fills the space between a machine's base and the concrete beneath it. Once it cures, the machine rests on a solid bed instead of on shims and high spots.

  • Nevada Contractors License 46276
  • USDOT 642556 · our own trucks
  • 4.6 on Google (15 reviews)

Key points

  • Fills the gap between base plate and foundation
  • Carries load evenly across the full base
  • Damps vibration and holds anchors in place
  • Cementitious and epoxy grouts are common types
  • Cure time must pass before final alignment is locked

Concrete is never perfectly flat. A machine set directly on it touches only the high points. Grout is poured or pumped under the base, flows to every low spot and hardens, so the whole base takes its share of the load and the machine holds its level.

Why machines get grouted

A rotating or reciprocating machine shakes its foundation continuously. Without a full bed under the base, anchor bolts take the stress, shims creep and alignment drifts. Grout locks the base in place, adds mass and helps reduce vibration.

  • Even bearing on the foundation
  • Protects anchor bolts from shear and fatigue
  • Helps hold alignment over time
  • Seals the base edge from oil and moisture

Where it falls in the install

Grouting comes after the machine has been set on its leveling shims or jacking screws and aligned to rough tolerance, and before the final alignment check. Forms are built around the base, the grout is placed in one continuous pour so air is pushed out, and it is cured to the manufacturer's schedule. Final leveling, with spirit levels and optical instruments, follows once the grout has gained strength.

  1. Prepare and clean the concrete surface
  2. Set and rough-level the machine on shims or jacks
  3. Build forms around the base
  4. Place grout in one continuous pour
  5. Cure, then check level and tighten anchors

ILS and foundations

ILS describes handling a relocation "from start to finish," including engineering services, foundations and specialized transportation. For a new location, that planning includes how the machine will sit. The grout product and thickness come from the machine maker and the engineer, not from a general rule.

Sources (2)

Send the machine details

Type, size, weight, where it is and where it is going. Photos help. Estimates are free.

Start the estimate

FAQ

Questions we hear

All questions

Is grout the same as concrete?

No. Machinery grout is a flowable, shrink-resistant material that works in thin layers under a base. Concrete has coarse aggregate and shrinks.

Can a machine be aligned before the grout cures?

Rough alignment, yes. Final alignment is checked after cure, because the machine can shift as the material sets.

Free estimates

Tell us what needs moving.

Free estimates on every job, big or small. Call the office or send the machine details and we will call you back.

(775) 882-3319

Monday to Friday, 7:00 am to 4:00 pm. Fax (775) 882-2693.

  • Nevada Contractors License 46276
  • USDOT 642556 · our own trucks
  • Carson City since 1999
  • 4.6 on Google (15 reviews)

Request a free estimate

Your details
The machine

Up to 8 photos. Big photos are resized on your device before they are sent.

Free estimates. Your details go only to Industrial Logistics Services. We call back Monday to Friday, 7 am to 4 pm.