Nevada oversize load checker
Enter the height, width, length and weight of a loaded trailer, and the checker compares them with Nevada's legal limits to show whether the load likely needs an over-dimensional permit or pilot cars. It is a planning guide only, and the Nevada Department of Transportation (NDOT) decides every permit.
- Nevada Contractors License 46276
- USDOT 642556 · our own trucks
- 4.6 on Google (15 reviews)
Key points
- Measure the total height from the road, not from the deck
- Over 14 feet high, 102 inches wide or 70 feet long as a combination, a permit is likely needed
- Gross weight above 80,000 pounds also needs a permit
- The checker is a guide; NDOT decides
- Permit holders must follow the route and conditions written on the permit
The numbers behind the checker come straight from Nevada law. This page explains them, so you can see what the checker is doing and why it gives the answer it does. Measure the whole load as it will travel: the machine, the trailer deck and anything that sticks out.
What the checker compares
If every number is at or below the limit, the load is within Nevada's height, width, length and gross-weight limits; axle weights and overhang can still require a permit, and NDOT has the final word. If any number is over, the checker flags that the load likely needs an NDOT over-dimensional permit and shows which pilot car triggers may apply.
| What you enter | Compared with | Rule |
|---|---|---|
| Total height | 14 feet | NRS 484D.605 |
| Total width | 102 inches | NRS 484D.685 |
| Combination length | 70 feet | NRS 484D.615 |
| Gross weight | 80,000 pounds | 23 CFR 658.17 |
How to measure
- Height: from the road surface to the highest point of the load, including the trailer deck and any tie-down hardware or accessories on the machine
- Width: at the widest point of the load, including mirrors, rails and anything hanging out
- Length: the whole combination, from the front of the tractor to the rear of the load
- Weight: the machine, trailer, tractor, fuel and anything else aboard; the machine's nameplate weight is only one part
This is a guide, not a permit
The checker cannot issue, approve or promise a permit. NDOT's Over Dimensional Vehicle Permits office decides, based on the application: the vehicle, the load, the exact route and the dates. Route restrictions, bridge limits, construction zones and seasonal rules can change an answer that looks simple on paper.
Nevada's pilot car rules (NAC 484D.670) kick in at larger sizes, and the table on our legal load limits page lists them. The code text controls, and the checker's results are only as good as the numbers entered.
Cutting a load down to size
A permit can sometimes be avoided by changing the plan. A lower deck, a different trailer, tilting or turning the machine, or taking off a removable part can bring a load within the limits. The code requires that a permitted load be non-reducible (NAC 484D.650), so this is the first question NDOT asks. Learn about trailer types on our equipment trailers page.
Sources (3)
- Nevada Legislature: leg.state.nv.us/nrs/nrs-484d.html (checked November 2026)
- Nevada Legislature: leg.state.nv.us/nac/nac-484D.html (checked November 2026)
- Electronic Code of Federal Regulations: ecfr.gov/current/title-23/chapter-I/subchapter-G/part-658/section-658.17 (checked November 2026)
Send the machine details
Type, size, weight, where it is and where it is going. Photos help. Estimates are free.
Start the estimateLicensed in Nevada
Nevada State Contractors Board licenses 0046276 (C-33 Installing Industrial Machinery), 0083124 (A-14, A-20) and 0083125 (C-14I Rigging and Cranes, C-14J Conveyance of Goods). USDOT 642556, MC-531191.
What the classes coverDoes the checker issue a permit?
No. It is a guide. Only NDOT issues Nevada over-dimensional permits.
What if my load is exactly at the limit?
Loads at or under the legal limits do not need a permit, but measure carefully. A small error can put you over.
Does the checker cover California?
No. It uses Nevada rules. A load going into California needs a Caltrans permit if it is oversize there.
Free estimates
Tell us what needs moving.
Free estimates on every job, big or small. Call the office or send the machine details and we will call you back.
(775) 882-3319Monday to Friday, 7:00 am to 4:00 pm. Fax (775) 882-2693.
- Nevada Contractors License 46276
- USDOT 642556 · our own trucks
- Carson City since 1999
- 4.6 on Google (15 reviews)
