3868 Goni Rd, Carson City, Nevada 89706Fax: (775) 882-2693Nevada Contractors License 46276Phone: (775) 882-3319
Industrial Logistics Services badgeIndustrial LogisticsServices, Inc.Machinery moving & installation(775) 882-3319

Spreader bar

A spreader bar is a steel beam that rides above a load and keeps the slings pulling straight up. It protects wide or delicate machines from the squeeze that angled slings create.

  • Nevada Contractors License 46276
  • USDOT 642556 · our own trucks
  • 4.6 on Google (15 reviews)

Key points

  • Keeps sling legs vertical
  • Takes the inward force on itself
  • Protects tanks, cabinets and wide machines
  • Has its own rated capacity that must be marked
  • Belongs to the family of below-the-hook lifting devices

Angled slings push inward on whatever they lift. That is fine for a solid casting and a problem for a thin-walled tank, a control cabinet or a machine with an overhanging cover. A spreader bar takes the sideways force and lets the load see only a vertical pull.

Spreader bar versus lifting beam

The two look alike. A spreader bar works in compression, with slings running from its ends down to the load. A lifting beam works in bending, with a hook at the center and lifting points below. Both are covered by the ASME B30 series of standards for below-the-hook devices, and both carry a nameplate with the rated load.

Spreader bar versus lifting beam
DeviceMain forceTypical use
Spreader barCompressionWide loads on two or more slings
Lifting beamBendingStraight pulls with a center hook

When a rigger reaches for one

  • The load cannot take inward sling force
  • Lift points are too far apart for the slings to reach steeply
  • Headroom is limited and angles would be too flat
  • A long, thin object needs more than one pick point

Where ILS comes in

Rigging, slings, hoists and more are on ILS's published list of equipment, and the crew plans each lift with the load's weight, balance and lift points in hand. Whether one is used on your machine depends on the machine, and the estimate covers that.

Sources (3)

Send the machine details

Type, size, weight, where it is and where it is going. Photos help. Estimates are free.

Start the estimate

FAQ

Questions we hear

All questions

Does a spreader bar need a rating?

Yes. Like any lifting device, it must carry a marked rated load and be used within it.

Does a spreader bar change the sling angle?

Yes. It spreads the lift points while keeping the sling legs vertical, so the legs carry close to their share instead of a higher one.

Free estimates

Tell us what needs moving.

Free estimates on every job, big or small. Call the office or send the machine details and we will call you back.

(775) 882-3319

Monday to Friday, 7:00 am to 4:00 pm. Fax (775) 882-2693.

  • Nevada Contractors License 46276
  • USDOT 642556 · our own trucks
  • Carson City since 1999
  • 4.6 on Google (15 reviews)

Request a free estimate

Your details
The machine

Up to 8 photos. Big photos are resized on your device before they are sent.

Free estimates. Your details go only to Industrial Logistics Services. We call back Monday to Friday, 7 am to 4 pm.